Allora... il punto della situazione è questo.
Ho un router regolarmente connesso ad internet e funzionante: un Sitecom WL-108.
Suo ip: 192.168.1.1
La guida dice di fare i seguenti passaggi:
Under Wireless -> Basic Settings:
* Wireless mode: Repeater
* Wireless Network mode: (set to match the host)
* Wireless Network Name (SSID): the SSID of the network you connect to
* Save
* Add 1 virtual interface
* Enter a new (unique) SSID of your choice
* Save
Under Wireless -> Wireless Security:
* Physical Interface wl0:
o Enter the necessary settings to connect to the wlan you'd like to repeat (if no security, leave disabled...but consider enabling security for both host AP and Repeater)
o Save
* Virtual Interface wl0.1:
o Choose the best security mode, which should be WPA2-AES whenever possible.
o Enter a security key
+ Note: When using security on both the physical and virtual interfaces, you MUST usually use the same security type, and exactly the same passphrase on both the physical and virtual ssid. If you cannot connect when trying different security or passphrases, make them identical.
o Save
* Note: If you experience problems when setting up for the first time, a leading practice is to configure without any encryption (i.e. setting security to "None") at first, until the unit is confirmed to be working properly, and configuring encryption as a later step.
Under Setup -> Basic Setup:
* Network Setup:
o Here you define the repeater's own subnet
o Set IP address to a different subnet from the Host AP you wish to repeat
o Example: if host AP is 192.168.1.x, assign repeater to 192.168.2.1
o Set up your DHCP range if you desire
* Save
NON HO IMPOSTATO IL GATEWAY, è CORRETTO NON IMPOSTARLO??
Under Security:
* Uncheck all items in the "Block WAN Request" section (except Filter Multicast)....THEN disable the SPI firewall
o Note: If you are very concerned about security, a Repeater might still work okay with the SPI firewall enabled. If you decide to leave it enabled but experience problems, keep this step in mind.
* Save
Applico i settaggi, riavvio il router, mi collego al router ma non ho accesso ad internet.
Ipconfig dice:
